Oxidized multiwalled carbon nanotubes modified with 2-(2-hydroxy-5-nitrophenyl)-4,5-diphenyl imidazole for solid phase extraction and preconcentration of some metal ions

In this work, a new procedure for the enrichment of the trace amount of Cu²⁺, Ni²⁺, Co²⁺, Pb²⁺, Fe²⁺, and Zn²⁺ ions based on the utilization of multiwalled carbon nanotubes (MWCNT) modified with 2-(2-hydroxy-5-nitrophenyl)-4,5-diphenyl imidazole as chelating agent prior to their determination by flame atomic absorption spectrometry has been described. The influence of effective parameters including pH, amount of ligand and MWCNT, composition of eluent, and coexisting ions on recoveries of understudy metal ions was examined. At the optimum pH of 5.0, all metal ions were quantitatively sorbed onto the proposed solid phase and completely desorbed with 8?mL of 5.0?mol?L^?1 HNO₃. The detection limit of Cu²⁺, Co²⁺, Ni²⁺, Pb²⁺, Fe²⁺, and Zn²⁺ ions was 1.7, 2.4, 2.3, 2.9, 2.8, and 1.4?µg?L^?1, while the preconcentration factor was 63 for Cu²⁺ and 94 for the other metal ions and relative standard deviations between 1.8 less than 3.0%. The proposed procedure was applied for the analysis of various samples.     

Determination of cobalt by air-assisted liquid–liquid microextraction

Abstract

A rapid and selective technique for extraction, preconcentration and determination of trace amounts of cobalt in water and pharmaceutical samples by air-assisted liquid–liquid microextraction combined with flame atomic absorption spectrometry is proposed. 1-Nitroso-2-naphthol is used as a complexing agent and 1-octanol as an extraction solvent. Parameters relevant for analytical effectivity, i.e. pH of sample solution, concentration of complexing agent, volume of extraction solvent, and number of extraction cycles are optimized using a Box–Behnken design. At optimum conditions, a dynamic linear range of 5–600?µg L^?1 is obtained, with a limit of detection of 1.2?µg L^?1. The method is used for determination of Co(II) in environmental water and pharmaceutical samples.     

Hazardous halogenated substances formed during combustion processes

The results of the emissions from combustion processes and/or from fire accidents show the risk to man and his environment and thus the need for strict legislation and critical analysis of unwanted compounds. These substances or their thermolysis products are often due to incomplete combustion or may result from the interaction of various substances.

In the following we report the formation of octachlorostyrene (OCS) and of high‐toxic substances such as polybrominated dioxins (PBrDD's), dibenzofurans (PBrDF's) by the combustion.

In order to determine a possible source of the non‐manufactured compound OCS, we conducted several model experiments in a combustion chamber at various temperatures from 400 °C to 800 °C. The thermolysis of chlorinated solvents like chloroform or of chlorinated aromatice like pentachlorobenzene produced—among other chlorinated substances—OCS as one of the major products.

Analogous combustion experiments with polyester plastics containing decabromodiphenylether as flame retardant and antimony trioxide as Synergist led to PBrDD's and PBrDF's. Here antimony trioxide seems to play an important role because in absence of this oxide, PBrDD's and PBrDF's were not found in our experimental conditions.     

Gulf War agents trigger discrete transcriptional changes in human neuronal cells

Reports on Gulf War illness (GWI) implicated the use of the pesticide permethrin (PER), and the insect repellent N,N-diethyl-m-toluamide (DEET), in its etiology, as well as pyridostigmine bromide (PB), which was given as a prophylactic treatment against nerve agent exposure. Using Affymetrix microarrays the genomic response of human neuronal SHSY-5Y cells to 10 days of exposure to these agents was characterized and profiles of gene modulation unique to each treatment were demonstrated. In particular, a significantly greater impact of PER was observed compared to the other treatments. The Ingenuity Pathway Analysis knowledgebase was used to analyze the genomic datasets and attribute functional consequences to the effects of related genes, which were significantly up- or down-regulated in response to different treatments. Canonical pathways shown to be significantly modulated at the genomic level in response to exposure included cellular mechanisms, which might contribute to the clinical presentation in GWI patients and thus be targeted for further investigation as potential targets for therapeutic intervention.     

超高效液相色谱-串联质谱法测定污水中14种有机磷酸酯阻燃剂

建立了超高效液相色谱-串联质谱(UPLC-MS/MS)联用法同时测定污水中14种有机磷酸酯阻燃剂(OPEs)的分析方法.样品采集后,经GF/C膜过滤,HLB固相萃取小柱净化后进样分析.以BEH C18色谱柱为分离柱,乙腈和水混合液为流动相(0.2 mL min-1)梯度洗脱,15 min内可完成14种OPEs的分离.在电喷雾正离子模式下,采用多反应监测模式(MRM)进行质谱测定.在加标浓度为1.0μg·L-1时,14种OPEs在污水处理厂进水和出水中的回收率分别为52.1%—119%、43.6%—114%,相对标准偏差(RSD)分别为1.2%—16.2%、0.4%—9.2%,方法的检出限(LOD)在0.3—6.0 ng·L-1间.方法精密度好,准确度高,可满足同时对污水样品中的14种OPEs进行定性及定量分析的要求.     

水体和甘蓝及土壤中毒死蜱残留检测方法

研究运用不同的样品前处理方式,在装配火焰光度检测器的气相色谱(GC-FPD)上检测,建立了有机磷杀虫剂毒死蜱在水样、土壤和甘蓝中的残留测定方法.研究表明,不同样品中的毒死蜱残留采用本文中介绍的前处理方法是可行的,用石油醚盐析提取和净化水样中毒死蜱,采用丙酮振荡提取甘蓝中毒死蜱,选用索氏提取法提取土壤中毒死蜱,并经液液分配净化后,采用OV-101大口径毛细管柱(30 m×0.53 mm×1.0μm),在装配火焰光度检测器(FPD和磷滤光片)的气相色谱上测定.该分析方法下,毒死蜱的保留时间为1.74 min,线性范围在1.0×10-11—1.0×10-8g之间,其线性相关系数为0.9998,最小检出量为2.0×10-12g.在设定的较低添加浓度的条件下,毒死蜱在水样、土壤与甘蓝上的添加回收率为80%—120%,变异系数均小于5%.该分析方法灵敏、准确、操作简便,适合水样、甘蓝和土壤中低浓度毒死蜱的残留检测.     

Sound management of brominated flame retarded (BFR) plastics from electronic wastes: State of the art and options in Nigeria

Management of flame retarded plastics from waste electrical and electronic equipment (WEEE) has been posing a major challenge to waste management experts because of the potential environmental contamination issues especially the formation of polybrominated-dioxins and -furans (PBDD/F) during processing. In Nigeria, large quantities of electronic waste (e-waste) are currently being managed—a significant quantity of which is imported illegally as secondhand electronics. As much as 75% of these illegal imports are never reused but are rather discarded. These waste electronic devices are mostly older equipment that contains brominated flame retardants (BFRs) such as penta-brominated diphenyl ethers (PBDEs), and polybrominated biphenyls (PBBs) which are presently banned in Europe under the EU WEEE and RoHS Directives. Risk assessment studies found both to be persistent, bio-accumulative and toxic. The present management practices for waste plastics from WEEE in Nigeria, such as open burning and disposal at open dumps, creates potential for serious environmental pollution. This paper reviews the options in the environmentally sound management of waste plastics from electronic wastes. Options available include mechanical recycling, reprocessing into chemicals (chemical feedstock recycling) and energy recovery. The Creasolv^® and Centrevap^® processes, which are the outcome of the extensive research at achieving sound management of waste plastics from WEEE in Europe, are also reviewed. These are solvent-based methods of removing BFRs and they presently offer the best commercial and environmental option in the sound management of waste BFR-containing plastics. Because these developments have not been commercialized, WEEE and WEEE plastics are still being exported to developing countries. The industrial application of these processes and the development of eco-friendlier alternative flame retardants will help assure sound management of WEEE plastics.     

甲烷-煤尘复合火焰的传播与温度特征

为了揭示甲烷-煤尘复合体系的燃烧特征,利用高速摄像机、超细热电偶、显微镜头等对管道内甲烷-煤尘复合火焰的传播过程及其温度特征进行了试验研究.结果表明,随着煤尘浓度的增加,甲烷-煤尘复合火焰的最高温度及传播速度呈现先增大后减小的趋势; 对于甲烷-煤尘复合火焰,粒径较大的煤尘在较小的浓度达到最高温度,而粒径较小的煤尘则需要在较大的浓度达到最高温度.     

爆炸形成过程中火焰加速的试验研究

为预防和控制工业爆炸事故,并为脉冲爆轰发动机的研究提供理论指导,分析火焰加速导致的燃烧转爆轰过程的影响因素。采用爆轰管探讨障碍物的阻塞比、混合物的组成、初始压力和点火能等4个因素对爆炸性气体火焰速度和爆轰压力的影响规律。试验结果表明:障碍物的存在能大大提高火焰速度和爆轰压力;爆轰压力随管内障碍物阻塞比的增大先变大后减小,并在阻塞比为0.498,燃料种类为天然气,化学当量比为1时达到最大;爆轰压力还随混合气体初始压力的增大和点火能的提高而增大。选择适宜的条件可大大提高火焰加速速率,促进燃烧向爆轰过程转变。     

典型木材燃料层流扩散火焰碳黑生成特性研究

为了对木材燃料层流扩散火焰碳黑生成特性进行研究,搭建了基于消光法原理的轴对称层流火焰碳黑浓度测量平台, 选用马尾松针、柚木以及红橡木三种典型木材燃料粉碎成针状试样,并堆成直径3.5 cm堆垛,利用酒精引燃后可获得稳定的层流扩散火焰,同时通过电热丝辅助加热延长稳定燃烧。通过对三种典型木材燃料层流燃烧过程的质量损失和火焰碳黑浓度的测量和对比分析,结果显示三种燃料中马尾松针碳黑生成能力最大,这说明木材的碳黑生成能力可能与其碳元素和氧元素的含量有关。